LightBlog

lundi 16 février 2015

[Q] Bricked XT910 UMTS while upgrading LiquidSmooth via OTA

I was using the Liquidsmooth ROM, I think 3.1, when on the update menu a new release (3.2) popped up. So I decided to perform the OTA Uptade. Rom downloads itslef, then the Phone reboots himself and remains stuck on the Moto logo...After one hour I resetted the phone via power+vol key combo and I finally met the infamous AP fastboot screen.

I have bypassed the low battery issue by buying a moto factory cable, so now the AP Fastboot screen says "battery ok" and "can program".

That being said, the situation is now as follows

1) If I try to load a ROM via SBF Lite I obtain the following errors:

a) trying to install the stock EU JB rom results in the following "1/10 phone returned fail"

b) trying to install both Cyanogen 11 or Liquidsmooth 3.2 results in SBF rejecting the ROM i.e. it doesn't even start to upload them into the phone

2) If I enter into recovery mode and try to install the Cyano 11 or Liquidsmooth 3.2 which are store in the micro sd cart, the install fails after the integrity check



So, now I'm stuck with a phone which could be programmed, thanks to the factory cable, but which cannot be programmed in non of the ways I've reported.



p.s.

AP Fastboor versione is 0.77



Thank you in advance for every bit of help you would mind to share





from xda-developers http://ift.tt/1ECteay

via IFTTT

Aucun commentaire:

Enregistrer un commentaire